chevy58guy
08-01-2004, 01:12 PM
I need advice regarding a clean pulley set up for my 348. Its a 1959 motor.
I'm looking to install an alternator, p/steering pump and ac compressor. I see
zoops has a nice set up BUT it appears i'll have to drill a boss out on the lower block and tap it for the p/s pump ( not too thrilled to do this :( and it looks like there is a plug of somekind like a freezeout plug but smaller in the same boss.) what is that for?
Alan Grove has an alt and compressor bracket but no p/s. That leaves me with
the stock setup. Is there a nice clean setup available for the generator/power steering pump assy? and what bracket should i use for the ac compressor?
Can any one help me with this problem? :? Thanks Joe
I'm looking to install an alternator, p/steering pump and ac compressor. I see
zoops has a nice set up BUT it appears i'll have to drill a boss out on the lower block and tap it for the p/s pump ( not too thrilled to do this :( and it looks like there is a plug of somekind like a freezeout plug but smaller in the same boss.) what is that for?
Alan Grove has an alt and compressor bracket but no p/s. That leaves me with
the stock setup. Is there a nice clean setup available for the generator/power steering pump assy? and what bracket should i use for the ac compressor?
Can any one help me with this problem? :? Thanks Joe