Telescoping Drive Shaft

[Geary Trussell]

I would like to know if anyone has purchased a telescoping drive shaft
from Inland. I would like to know the shaft length measurements for a Borg Warner 4 speed and stock rearend. My car is a 59 2door Impala. I am trying to get a jump on my frame off restoration and get the drive shaft made before
I get the engine and transmission back in the frame. I called Inland but
they insisted I get the actual measurements, but this is a stock type
application and expected them to have those measurements. Has someone
already done this if so your help would be appreciated.

thanks

[fatride]

I have the 1310 telescopeing driveshaft from Inland. Good piece.

[fourspeed409]

Ray
Why did you go with the 1310 shaft instead of 1350?
Shane

[jim_ss409]

I think I can answer that! :scratch automatic transmission! :deal :D

[Geary Trussell]

Thanks for the replies but does anyone have the measurements?

[64ss409]

I don't have U joint center to center measurements. But here is overall length measurements taken from the parts book. Hope this helps.
Front propeller shaft 59-64 Pass w/4spd 24 5/8 (O.L.)
Rear propeller shaft 58-64 36 1/2 (O.L.)

Maybe someone else has a driveshaft out and can measure center to center.
Ron

[Dond409]

I just had my drive shaft worked on, The rear section is 36 inches center to center. The front section I had made to the 4 speed spec of 24 5/8 center to center. It's in the car and is working fine.