Shifter Hole

[fourspeed409]

Can anyone give me the specs for the size and location of the shifter hole in the floor. My car is a 62 2 door post that I am converting to a 4 speed with bench seat.
Thanks

Shane

[Tom Kochtanek]

Shane:

Somebody else probably has this info, but I can take measurements for you if you still need them. I did this on my 1962, converted from a PG to a four speed.

I did get the patterns from the 1962 Shop Manual (as I recall). I also have what I believe to be a section of floor board from a 1961 factory four speed. The measurements match.

I can take some pics as well if you'd like :).

Good luck!
TomK

[fourspeed409]

Tom
That would be great if you could get me some measurements. I am at the stage that I need to start mocking stuff up, before I start spraying the shiny black paint.
Thanks
Shane

[Tom Kochtanek]

Shane:

Sorry, didn't get out to the car this weekend, busy with other things. Will be back early next week, perhaps someone else has the specs?

Best,
TomK

[chevymusclecars]

There is a couple of pictures in this thread that should help.

http://www.348-409.com/forum/showthread.php?t=4746&highlight=tremec

Bill