pushrod tools for W engine

[models916]

I am done with these, hope to pass them on to someone in the forum. Very accurately set pushrod length on engines with decked blocks or milled heads and longer vlaves and studs. Get the geometry right! If you are high bidder and tell me you are in the 348/409 fourm I will refund the $5.00 shipping when I send the items out.


http://cgi.ebay.com/ebaymotors/ws/eBayISAPI.dll?ViewItem&item=4589058595&rd=1&sspagename=STRK%3AMESE%3AIT&rd=1

[fatride]

Will it work for roller lifters as well?? Thanks.

[models916]

The lifter and the adj. pushrod are a moot point but the tool on the valve should have the same results with a shorter adj. pushrod and roller lifter (Hyd. plunger sunk to correct depth.) The tool was about $18 from Jeg's.