Negitive Camber Problem

[soloprez]

I replaced all parts on the front end of my 65 Impala. I to am having a negative camber problem. When i pulled the old parts off there were no shims for adjustment. So i have assembled it without shims. Im not sure what to do to fix this problem. Its in pretty far. And moog makes an a arm shaft with offset, would this help do shims help negative camber, if so, where do i get shims. Just want to get this thing close before an alignment..

[jester]

The camber adjusting method is different on the 65 then that on the 64's. The camber adjustment is on the lower control arm . loosen the big not and reach through the big hole in the other side of the chassis with a big socket and turn the eccentric . Lock the big nut back up.
P.S. Don't drop the socket in the chassis.
Good luck :rofl