Tic's60
04-22-2007, 03:02 PM
hmmmm seems all these hours have made my brain go to mush!
Does the opening point down and which holes do I use the upper or lower ones?
As an update the front half is done!! Had to have my drivers side header redone so I lost a few days on it. Also tested the Predator carb on my old trucks sbc. All I can say at this point is that very touchy is not even close to describing the throttle response or adjust the dam thing. A 1/4 turn is 1/8 turn to much!! :eek:
Got it worked out though.
Some update pics as well
6947
6948
Does the opening point down and which holes do I use the upper or lower ones?
As an update the front half is done!! Had to have my drivers side header redone so I lost a few days on it. Also tested the Predator carb on my old trucks sbc. All I can say at this point is that very touchy is not even close to describing the throttle response or adjust the dam thing. A 1/4 turn is 1/8 turn to much!! :eek:
Got it worked out though.
Some update pics as well
6947
6948