The bead roller of awesomeness!

bobs409

 
Administrator
Bob if you come up with some tool steel I can harden it for you, if fact I have some D-2 I can send you if you want to pay the shipping.

Thanks but these are good enough. You would have run miles and miles of material through to wear these out.
 

bobs409

 
Administrator
A few "improvements" have been made worth mentioning. First, I added wheels so when tipped back, this can roll around easily. (may upgrade to a wider track yet for more stability) I also added clips to each peg the bead rollers are stored on so they don't fall off when tipped.

At the other end, I designed an adjustable tilting table that should offer some new possibilities. A square tube was welded under the bottom roller as a reciever so when needed, the new table set up can be slid in. The table top section is removable and a small fence can take it's place that I'm still working on. :weld

What will those engineers think of next? :crazy

DSCN7774.jpg DSCN7771.jpg DSCN7772.jpg DSCN7773.jpg DSCN7775.jpg DSCN7783.jpg
 
Top