Wilson Header Mfg.

[Blk61409]

Patiently awaiting feedback. Thanks guys.

Beginning tomorrow

 

[Jeff Olson]

Welcome. Looks like you have an excellent product.

 

[David Aughenbaugh]

I just bought a set of Doug's too!...Damn, I'm always freaking day late and a dollar short!

Good Luck Mark!

 

[Mark Wilson]

Headers are installed on Pat's car and I will post pictures a little later. No problems, but will make a few minor changes for better clearance. Pat's man Al said they were the easiest 409 headers that he has ever installed.

 

[Mark Wilson]

First images from under car.

 

[Mark Wilson]

Drivers side generator mount.

 

[Phil Reed]

Something is askew....the upper power steering bracket should not need to have the top cutout for the generator bracket.
Looks great!!!!

 

[Mark Wilson]

Drivers side prep for install. Z bar and oil filter removed. drivers side slid into place

 

[Mark Wilson]

More drivers side. bell housing clearance port 7. drivers side motor mount cross member clearance ports 1,3 and 5.

 

[Mark Wilson]

Drivers side frame clearance and lower control arm.

 

[Mark Wilson]

More drivers side

 

[Mark Wilson]

Drivers side motor mount. This mount had been trimmed previously for another set of header. And it appear the same will be needed for mine

 

[Mark Wilson]

Now onto the passenger side

 

[Mark Wilson]

More passenger side. #8 tube is clearing bellhousing, but by only about 3-4 paper sheets, also touching fuel line. I think it would be much easier to adjust fuel line, I can suck port *8 tube in closer to the head, but will make it extremely difficult to access the lower header bolt.

 

[Mark Wilson]

And more passenger side. Starter , frame and lower control arm clearance.

 

[Mark Wilson]

Just one more. That's it for tonite. Let me know your thoughts.

Mark

 

[Blk61409]

First images from under car.

Something is askew....the upper power steering bracket should not need to have the top cutout for the generator bracket.
Looks great!!!!

Yep, had to make one, can't find ours . You didn't pick it up when you were here last did you??

 

[acacg]

Something is askew....the upper power steering bracket should not need to have the top cutout for the generator bracket.
Looks great!!!!

That bracket is special!

 

[Phil Reed]

I know Alex!!!!!!! There are 2 different brackets that extend over to the generator.....1 for power steering and 1 for standard steering. Think if you got the right one you should be good to go!!!!!

Looks like you make a real quality product Mark!!!

 

[nana1962409]

Looks like they fit pretty good. Will be interesting to see how they fit around a Lakewood or QuickTime bellhousing as well.