Recent content by bergsgrd

That's just what I need. Let me know what you want for it.

That's what I need let me know.

I have cut one out of one of my parts cars but would like to find a new one.

The right side was a full quarter panel but did not come with that tail light panel. I bought a panel and it was welded into the quarter on the right side. The left side is a little rusty so I thought I'd replace that side as well. The original quarter is still in place just that I need to...

Left side tail light panel that attaches to the quarter panel.

I need part of the quarter panel.

No, I need the left side housing that the taillight attaches to. The right side was available when the right quarter panel was replaced but now to finish off the body work I need the left side and it is not available. I ordered one from Hubbards a year ago and it keeps getting backordered.

Anybody out there have a connection for a left side tail lamp housing? New or used. I ordered one a year ago and it hasn't showed up.

My kids grew up going to Late Great events in our red 62 Impala. Sioux Falls, the Twin Cities, Dea Moines. I submitted tech articles, bought parts and really enjoyed the association. This last fall I had called SE coast Chevys and had really good conversation with Danny Howell about the Good old...

I haven't had a chance to get over and check the situation out firsthand. I know he cut high into the sail panel area where the seam comes down from the back window to the trunk. I bought the quarter from CARS and all the body lines and wheel opening were very crisp. My metal man says he can fix...

Well guys I ran into a real snafu. I gave my body man a new 62 passenger side rear quarter for an Impala and of course that doesn't fit a Belair hardtop. He already cut the old one off and was fitting the 'Impala' one on and found out they are different. It was my bad because I gave him the...

Here are the reveal moulding clips for the windshield. The old originals show the screw and they are just a slight bit different than the new one. I really do think the new ones will work. All the originals on the 61 donor car are still intact so I might use them. I've been warned not to mix the...

I've bought clips from Hubbards Impala and they look pretty close to the originals. Is that the Black Belair you're working on? I'm surprised that you even need new clips with the condition that car is in. Too bad because if you have bad clips, your W/S will have to come out to replace them...

The clips slide on the windshield opening lip, then are attached with small screws before the windshield is installed. There are two on the side, one about 3 inches from the top and another about 3 inches from the bottom. I just opened the windshield area on my 61 Belair Spt. Cpe. donor car to...

The moulding is a press fit on the clips.