Recent content by boug58

Do you have pictures. I have 58 impala with 348 stroked. I have a 3 duce on it for the last 16 years. looking for reliable system to take long trips. and what intake did you use. I bought a Edelbrock 7159 a few years back it is a dual plane would that work. thanks please get back with me ...

i found a 1962 impala 8 cylinder 2d spt cpe winder sticker at a auction paint code is 950A which is Ermine white/ tuxedo black also it was assembled in janesville wi. i have the vehicle vin . if you think this could be your contact me. boug58

500 cfm or 650 cfm can I run with my 348 with 2.07 and 1.74 valves

thanks guys for the reply

His name was curt Harvey not first name steve

I have a 1958 impala with a 348. When I first rebuilt the engine, I purchased a rotating assembly kit from Mr 409 out California. I believe his name was Steve. Of course he is out of business. With his kit I received a 6" OD aftermarket harmonic balancer. Know I,am looking to put a March...

having flooding problems. can you please tell me what should I be running for fuel pressure for the 3 carbs

thanks a lot guys that is what my new impala is 283 2-barrel Rochester and auto trans thanks again . another question I have my other impala with 348 tri-power front and back carbs leaking fuel down venrturi after I turn it off please help

Mike can you tell me what does each letter and number mean thanks

I just purchased a 1958 impala and on the suffix pad is just F4IOD please help

Looking for someone that can tell me who rebuilds 2 barrel rochester carbs,they are off of my 348. They are not the correct ones by numbers. I,am having problems with the accelerator pumps and linkage. Also front and back carbs will stick at times with the throttle wide open by hand. There is...

I have been looking for some part numbers for the windshield moulding for the 58 chevy cars and station wagons. I found and old copy of the Late Great chevys April of 1983 Vol3 No6. By the looks of the part numbers It looks that the bottom two mouldings RH and LH are the same on all models...

Please see if you can get pictures. thanks for the answer. Raymar58454 if you can get some pictures of the upper control arm if would like that very much. Again I went out today and removed the wheels from my 58 impala. tomorrow I will take another look at them. If I can get the pictures that...

from boug58 My question is can I have the wrong upper a arm on the wrong side. the shafts are on the correct side,because the side for the steering column has the little bend in it . Can any one please help me out . Walkerheader thanks for the reply.

Hello gang I have my 58 impala and I went for a front end alignment. The readings on the front left caster is -3.2 and the front right is -3.6. The man told me that the upper ball joint should be behind the lower ball joint , Mine are both ahead of it that is my problem. When I did my car...