Recent content by El Rat

Hi gents What “brand” x frame center support do you all use? I think that the polyurethane / billet designe would be best however I don’t want to spend on splined back shaft. Ty rat

Wife!

Is balsa “wood”?

NP.

I like that plasta-gauge. The tip off was when the oil pressure just creeped up. What a maroon!

I have proven beyond a doubt that if you are dumb enough you can trap a plastic* oil line between the transmission and engine block! * I know only a maroon uses a plastic oil line!

I think I would contact POR-15 and/or Eastwood and (axe) them for a recommendation.

Some of you folks have obviously NOT watched Bugs Bunny he originated the term MAROONS!

My 09 is pretty nice on the underside except that it was under coated. I originally thought it was to hide defects but no doesn’t seem so. Despite the under coat the bottom is Ok. NOW MY POINT the maroons sprayed undercoat over mud in the wheel wells. Are you shixxen me! It’s 3/4 inch thick...

I had two 60 impalas (in my kid days) both had rust under the chrome trim on the rear fins. I like POR 15.

someone went to a lot of trouble to move the dipstick.

Times where simpler then.

Staged but kool!

1st Trump then Rush I’m sick. I must have done something wrong.