Have you personally seen the block to confirm its a 422 without an X or is that what the seller is telling you? Perhaps he doesn't understand where the X is located. I put no bearing in the presence of the X.
(Lack of) cracks and machined surface conditions are the important things.
Panels, frame members, and other parts do get pulled on. What do you think causes panels to stretch when they're dented and require shrinking to pull the dent out? Every dent and ding has a tensile stress component. Tension and shear are what pull spot welds out of panels and cause them to rip...
Collisions most certainly impart tension, shear, and bending stresses upon parts. Tension and shear are what rips welds and panels apart.
There are varying types / strengths of panel adhesives. With some the steel will rip apart before the adhesive joint fails.
Anyone who thinks this would actually happen is delusional. It would first require he be made Speaker of the House, which would be an incredible break from precedent and won't happen since there aren't likely enough hardline MAGA nutswingers to open that can of worms. Secondly, it would...
Without even leaving this page of this thread, "The only things i believe Trump did wrong was tweeting stupid shit and hiring Fauci."
Increases in fuel prices are driven by increased demand and lack of supply, which is the inverse of why they dropped during 2020 - a sudden decrease in demand...
Where did I state a President's decisions have no consequences? Presidential decisions can certainly have consequences, but it depends upon what the decision was and what it was in regards to.
I stated a President has little to no influence on the petroleum markets. Especially so in the...
Great. However, if you support Trump and would vote for him in 2024 then you're not really following that ideology.
Whoever said the low fuel prices were a lie? Do you understand why fuel prices were low during 2020 and why they've since risen? Neither were or are due to Presidential...
A block from that timeframe will have the pads for the coolant passages, but they may not be drilled. If the 791s are original to it - which is possible - the pads will be blank. I have a March '58 block with pads sans holes.
The economic and jobs data comes from the same sources as used by previous administrations. If it's lies now, then it was lies then, too. :dunno
Upgrades around the perimeter have been in-process for years. Planning started during the Obama administration and construction began during...
It's literally just a construction barrier around the fountain, though. But, hey, who cares about facts, right?
https://apnews.com/article/fact-checking-801204258687
Consider the source. Another phony story - you can bank on it. People will say anything for a bit of the lime light, and websites will write anything for a few page clicks. Trump lost. Get over it.