Recent content by Jaime arias

Hello everyone if there anyone interested in a nice rear end I have for sale took it off my 1958 impala with wishbone $400 in the las vegas area let me thanks

Those anyone no where I could get some repo scuff for the cruiser skirts..the long ones not the little skirts please let me know thanks

Hello everyone I got a question dose anyone have a clear set of copy of a installation instructions on a continental kit for a 1958 impala please let me know or guide me in the right direction where I could get one I would really appreciate it thank you

Yes I just went to speed shop and they had one conversion kit there im about to install it thank you....HAPPY HALLOWEEN EVERYONE

Whats up everyone I hope everyone is good..does anybody know what oil conversion kit to put in my 348 engine...or does anyone have one..

Thank you Don for the information I got told the opposite Im glad this site exists alot information

Hello everyone I have a question for the old fuel pumps what was that top port use for ..I was told it was use for wiper...how true is that is that information correct or is it used for something else please let me know thanks

Ok but on the filler neck there nothing there for it to connect is there something we got to put there for vent..please let me know don thank you for ur help

Hello everyone I have a question regarding a 1958 impala gas tank if you see the picture what is that port that comes out on the left side where the gas fuel goes not the sending unit its a little port on the side if anyone knows what goes hook up or what I run there I would appreciate it

But I was reading and its say low mount you have to remove battery and this 58 has the battery

Thank you very much for the Information.im trying to see what bracket this is as well I see Allen show Cars.thank you

Whats up everyone..what bracket do you guys use for the 508 air compressor for a 348 engine could someone please give a part number or a name would appreciate it:winner

I just fabricated my lower control arm and used 1980 spindle resolved that problem but thank you for the information

Whats up everyone hope everyone been staying safe and healthy have a bless and positive day :winner

Yes but the only problem is where the pin goes i have to snug to in order to put pin in