Recent content by Jayz63

Okay I’ll try the lower threaded rod. But where on the fork will I hook it up to unless the dimple that the current fork is sold for an adjustable one. Thanks

Okay so after measuring all my items. It appears I might have the wrong clutch fork. See attached photos. Tell me if you all agree. My fork if lying flat from my angles with the pictures I took shows it at 2-1/4” in height.

Thank you so much. I will be measuring my items. I know for sure I have the correct z bar lower push rod. I’m questioning my clutch fork. What is the length of the upper clutch rod. Thank you.

Hello Ross. Yes I have the aluminum 553 BH. The 509 z bar from show cars the lower push rod with the nipple that goes to the clutch fork. Not sure if there is a sbc clutch fork and specific 409 one. Yeah would you please send me some pictures so I can compare. Thank you.

Thank you everyone I will see if I can get a bigger throw out bearing because that I see as the correct fix. Be safe out there everyone.

Yeah the rod replacement is by far the easiest avenue to go but I also want to make it right I’ll look for an adjustment one

Shoot this is a great point. I never questioned the length of the throw out bearing. What is correct length. I just installed the one that came with the kit.

Hey every one. I hope all is well in the 409 world. I’m trying to figure out if my clutch rod is too short from my pedal. I believe it’s about 20-21”. I have it fully adjusted out and I’m not sure if I have a clutch disc issue or a push rod issue. I have the correct z bar and fork. I was...

Thank you all.

Hello everyone again. Would anyone suggest a power glide over a turbo 350 with a stahl torque converter with 4:11 gears in the back. Which one would be a better choice

I’m looking for a 111023 if possible or even a different year distributor. Please let me know if someone has one for sale 505-321-4990 text or message here thank you Jason

Okay it appears I have a small block z bar the #5321 in the show cars catalog. Does the #4289 with the shorter arm (2-7/8”) give me more adjustment?

Yea I have my show cars catalog. I will refer to that image. My fork does have the little crater that the push rod goes through with little nipple. Thank you guys so much I’ll see what z bar I have when I get home in a few days. Any the only place I can see to adjust my clutch is the upper...

Hello everyone it’s been a minute since I’ve been on here but my 409’is getting stronger every time I drive it. But I’m starting to think I have a SBC z bar in my car right now because my adjustment is maxed out. Is there an easy way to identify the 409 z bar from the SBC? Thank you.