:bang:bang:bang out working on my 58 Imp.using a 4 inch grinder .disc broke and knocked the grinder out of my hands. got tangled in my pants just above my right knee. ripped my pants open to find a 4 inch x 1 inch deep cut . 1 hand putting pressure the other one dialing 911 . They sent...
2 piece valvecovers
I made a set about 7 months ago . I used 6065 al 3 inch thick and a 1 inch thick top plate, I made mine with a 1/2 inch thick wall. i countersunk the 6 bolts (1/4X20X3 1/2inch ahcs) and used 18 1/4X20X1 to mount the top plate. the first one didn't come out too bad.I was...
has anyone converted one to EFI? what controler are out there? I have a 348 with a MSD coil per cylender setup so I have a cam and crank signal. I need to get fuel rails,pump,map,tps and o2 sencers. I have the bit and spuds for injectors.
early 348's
a easy way just by looking at the blocks/heads is the first gen headsthe set where the plugs screw into are thin about 3/8 inch and should take the 3/8 reach spark plugs. the 2nd gen have a thicker boss hence tha water jacket there about 3/4 to 1 inch thick