Skip FIx's latest activity

Eagle, Scat or the Molnar rods are all good quality and reasonable in price. by the time you get new bolts and rehone stock rods you...

Check with Crane on that specific cam and what type gear they recommend. Some actually have a pressed on cast iron gear. Generally GM...

Hooker does make some sidepipe headers so will probably go with them.

I vaguely remember a picture in a Hot Rod Book of Engines(maybe #3) in the high school library of a W in a boat with M/T valve covers...

If you change to studs you will need to do a touch up line bore/hone. Sometimes the under head shoulder on an ARP is a smaller diameter...

Either a tapped thermostat housing or drill an tap another hole in the water crossover.

One of my Mopar buddies using a wide band even saw big swings between batches at fill ups with pump gas!

I would think cryoing them also might be something to do.

I have that picture in my 1968 Motor's Manual I never returned to the library! But paid for it

I had bought a used a 4.11 posi with a ring gear spacer(high school kid did not know anything about those). Jumped on it one day and...

No 12 bolts from the factory, but Tom's Differentials and now Strange has conversions($$!). They were a 10 bolt from 63-82 17 spline...

Loctite might have been OK but I felt better with safety wire, Did that on the Stef's pan tray also after Teflon coating it.

I drilled and tapped the Edelbrock intake. Allen head bolts blue loctite and safety wires!

The Edelbrock dual quad has bosses for a factory splash pan underneath also.

Our Impalas etc with a pumpkin take a 17 spline pinion. 63-82 vettes also did. But all the new gear sets for them use a 30 spline -which...