SSpev's latest activity

:yup:yup I had one for sale at $100 but it need derusted and turned.

anyone ever try milling the top off a small port intake then adding on a dual quad top?

Sometimes I think the 379s get a bad rap, when they are perfectly fine on a stock-ish 348, and they keep the compression up a bit over...

What is this car going to be used for? Driving the living $hit out of it! :woohoo How serious are you about making it plant? At the...

Resurrecting this as I now have the problem. Just put in an eaton limited slip with 3.55 gears in the 64. Dump the clutch and WHEEL...

With all this under sizing and no one has said anything about the strength. All this cutting is reducing the overlap between the main...

That how my grandpa taught me to do it. :good any time I don't have one.

SE Obsolete CAUTION: Not suitable for use in most gasoline-powered automotive engines built after 1979. SD Obsolete CAUTION: Not...

Yes it was a 4 dr ht. I'd drive it but I don't know that I would pay for it.

https://www.facebook.com/marketplace/item/1101644344353153/

Thought I had posted on here about the 700r4. They are really hard to beat performance wise. Sure they have some draw backs but they...

If the TH350 is good it will never happen with a stockish 348. Mine was beat on daily with a 410 gear, never an issue. YES !! build...

Scott the picture is not at tdc. look at the 2 center pistons. they are off set. At tdc they would be even. 30 in the hole, with a...

:bang :bang:bang