Update I have oil on both sides and 60 psi oil pressure .I am not sure why. I broke out my air drill and after forever the oil press jumped to 60 and oil started flowing. My guess is that the relief valve stuck in the oil pump and or there was air in the oil. Thanks for everyone's help and advise.
This is the primer I used. I ran it with a 1/2 inch drill for around eight min. and no oil at all on either side and only 25 psi. I will pull the intake next and check the lifters. Thanks for the help.
Hello, I have a oil pressure problem with my 409. I have no oil on ether side of the rockers. I primed it with the show car tool and it shows' 25 psi . It has a high volume pump with 20-50 wt oil. The short block was built by a shop that has done several 409s the rear cam baring is installed...