Recent content by Tgpj1963

Thank you My block has a hole in the same spot as the 409. But it smaller than the pivot ball.

Yes it is back closer to bellhousing. That is back to far and does not have the same thread as the pivot ball.

I will double check but it is the only hole that will line up with the z bar. And it smaller than the pivot ball.

Okay I will keep looking for a new pivot ball. Thank you for the response.

The pivot ball is a 1/2×13 and the hole on the block is 3/8. So I am not sure if I should be looking for a different pivot ball or does the hole on the block need to drilled out and tapped. Or what the correct way to make this work.

Hello everyone I am building a 63 impala I found 25 years ago. I have 396 with a muncie 4 speed to put in it. I am having trouble with the bellcrank pivot ball bolting to the block. Does anyone have a fix for this? My pivot ball is a 1/2 bolt the hole in the block is a 3/8 or 7/16. Thank...