Recent content by Tic's60

When you do get the driveshaft done take it to a truck driveshaft shop so they can bolt it all down and spin balance the assembly. Makes a huge difference. I bought my telescoping one from an old drive shop guy in Arizona. The telescope slide on the back half makes things nice. anyway spin...

Here's a video of the car running. Had been sitting all lonely like in the shop for a few weeks so she's a bit cranky like most old lady's. You might also say I am chumming the waters as me an her are going to have to part ways at some point.

Thanks everyone. Been a rough couple of years with life death an unwanted retirement and a complete redo on the motor I am still going forward. New lemons headers, 1850.00 with a 6 month wait, installed, custom moroso oil pan, all yellterra valve train and a water methanol system I built to...

Nice! Been thinking about doing something for the 60 like that. I have a split bench front seat now but I don’t see any issues.

Still alive and mostly kick-in just a bit slower ... except for the chevy

Been many years since I had any and I forgot where the two lower tabs on the top part are bolted to. They come out the bottom corners and look like they bolt onto something but I cannot find any holes. Anyone have any pics or ideas where they mount to?

Been building these for awhile now using some of Grumps and Paul Blevins mods. Ran them before on my tunnel ram with good results and the AFB's are being a pain so today the swap. I do plan on going through the AFB's over the winter and see if there's something broken in them. Till then the fuel...

I run a two piece telescoping with 1350 u-joints and a aluminum carrier bearing assembly. There's a guy in AZ that builds them just do a search here in the forum.

Anyone seen a kit or have some ideas on how you could put shoulder style seat belts in a 60 Bel Air Post? Went back to my nice comfy bench seat and am looking for some better belt ideas. My other thought is a tube across the the seat width behind the seat then I could attach my should harness...

Asked him as well: 78-79 they are the same a lot of years just measurer the size 1 1/8 they fit good you may have to add or weld a bracket in because of the bigger size of bar I have these on my 60 impala and 55chev as well 1965 chevell

Just read a post elsewhere that the front sway bar off a early firebird firs the 58-64 full size and am wondering if it's BS or will in fact work.

I used a spare gauge housing drilled the holes and used machine screws to bolt it down. My 5" monster tach was on there for years with no issues so I figured why change ...

They are cool! Here's a better shot of the colors.

Some progress ..

Dropped in the new jets, metering rods and some 8hg springs per my vacuum reads and everything's running allot smoother. One thing I am using now that may or may not interest others is a a product by 14point7 called iDash that allows you to monitor your motors AFR, Oil, temp EGT and more. My...