Recent content by turbo38s10

I've used the Pertonix version with their coil and liked it, set it and forget it. You need to run the correct coil with them. These are a knock off I think.

Is it possibly for a boat application? The angle of the carbs looks pretty steep for a car.

I have a tank inc tank with my FItech on my 409 and I'm only using the original gas filler pipe and vented cap and it works fine. If you use the vent line it needs to be above the top of the fuel tank to vent correctly and I would not vent it under the car, that would possibly trap fumes under...

try this 348/409 thatwas custommade

Call CPP or one other brake companies. I believe your booster is to small. I run the 8" dual with 4 wheel disc and the extra vaccum tank in the fender well the impala's use. No problem. Even with lower vacuum at some point when you release the throttle your vacuum climbs and with the spare tanks...

just curious, shouldn't these angles be measure with the frame level? It just looks like it should be to me otherwise the angles will be off by the angle of the frame. The manual pictures also look like the frame is level although I don't think it says.

first find L6 or V8, then your car model #, then your engine. this gives you a number 1-13. then go to the bottomg and look up your number and it tells you the correct spring.

Spring charts: https://patchjob.files.wordpress.com/2018/04/1963aim-1.pdf Height chart: https://patchjob.files.wordpress.com/2018/04/1963aim-1.pdf

Just an after thought. With all the changes are you sure your engine is clearing the cross member?

This may help someone who needs the frame member: https://www.ebay.com/itm/1961-1962-1963-1964-CHEVROLET-IMPALA-BEL-AIR-REAR-FRAME-CROSSMEMBER-REAR-AXLE/331481994811?fits=Year:1961|Model:Impala&hash=item4d2dddd63b:g:7HoAAOSwv0tU4m7v&vxp=mtr or this make also help...

Does that 1/2" include the frame? That appears to be the only place on my 61 conv that it is less than that 1/2".

I found the correct one threw PVS409 Paul. No wiring issues. SDR0031-L and muxch cheaper than show cars. https://www.dbelectrical.com/products/chevy-305-350-454-mini-racing-pmgr-starter-ht-sdr0031-l.html here is the post...

Thanks all. I'm just finishing up putting Mark's headers in and when it came to the starter I had to have help putting the starter and header in together since you can't do them individual. That's why I asked on the smaller starter. I would like to be able to change it without unbolting the...

Any idea on a part number? Like this one maybe? https://picclick.com/Chevy-Astro-Van-Starter-43L-91-92-93-161336751723.html or this https://picclick.com/New-Starter-43-43L-Chevrolet-C1500-C2500-Pickup-132219407430.html

What starter are you using?