Recent content by twoteam

I skeered - boreing 348-409 Right on Buildit. That is why I suggested the machine method first. Properly set up you can compensate for error. The old deck mounted stuff just gives a cheap job. I mentioned it since I thought a cheap method was being looked for. I have the Rottler myself and...

Just about any shop that has a boring bar machine usually has a degree plate that they can mount. then it is no problem or even added expense. Can be done on old stand alone bar if they have a degree plate but bar has tendency to slip and ruin cylinger walls. Good luck with the 348. All...

Z Bar problems I had this problem twice with a 1964 Chevelle. Check and be sure that rod from clutch pedal is straight a Z Bar. Some were sent through so they mounted a slight angle. Angle causes breaks over time. Either do as others say and brace or buy updated Z Bar for 1965 up with one...