Kevin wrote:
"I started off with solid mounts from motor state. I milled the 3 holes for the block up to let it move as much as it could down there. Then I made slugs for the holes for the frame mount. I welded one hole shut and used a transfer punch going threw the frame mount, drilled that hole, welded the other hole shut and transfer punched from the whole I just drilled. I held the motor up of the cross member with wooden wedges a heavy 1/8" . A LOT of screwing around but I need all the hood clearance I can get ! And I'm sure there is probably an easier way but where is the fun in easy ?? lol "
"I started off with solid mounts from motor state. I milled the 3 holes for the block up to let it move as much as it could down there. Then I made slugs for the holes for the frame mount. I welded one hole shut and used a transfer punch going threw the frame mount, drilled that hole, welded the other hole shut and transfer punched from the whole I just drilled. I held the motor up of the cross member with wooden wedges a heavy 1/8" . A LOT of screwing around but I need all the hood clearance I can get ! And I'm sure there is probably an easier way but where is the fun in easy ?? lol "