409 Intake Heater and Bypass Hose Fitting

409forever

Well Known Member
Supporting Member 2
Hey All
Does anyone know who may supply these two fittings?
I believe that the fitting for the heater hose may be a standard threaded hose fitting but the bypass appears to be a press fit
The 2x4 Aluminum intake I have is not threaded for the bypass hose fitting.
I also have an early 348 single 4 bbl Aluminum intake (1960) that in someones infinite wisdom somehow put a fitting in the bypass hole then put a bolt in with JB Weld not sure if this hole was threaded or not
Need to remove to put correct fitting in
Question would be were both intakes press in fittings or threaded
Any and all help will be appreciated
Thanks
 

Jim Sullivan

Well Known Member
Supporting Member 10
I picked up a few of the press in fittings a couple years ago. I think I have the box for one on my bench. I'll try and remember to look tonight.
 
Top