Yeah tightened it down but to where you could still spin hub and then back off ,then spin and Snug it to get freeplay out. I don't think I was setting the pre-load right .I didn't leave it tight .
You do need to spin them and snug at the same time to work the grease out.
It is a touch or luck kind of thing.
With a taper wheel bearing you want 0 to very little play.
If you are use to ball bearing that is different as you want some play.
Yeah tightened it down but to where you could still spin hub and then back off ,then spin and Snug it to get freeplay out. I don't think I was setting the pre-load right .I didn't leave it tight .