Thanx , most of the research I have done points that direction , not so much towards the 658a!!6004 is correct for your car. Don't know any number that will raise it.
I will pick up a couple of 1/2" spacersThanx DON , I will give that a shot
are they rubber or metal and do you know who sells them? THANX SMITTYI've found , after buying several sets, various brands of springs, none would bring the front up. Spacers work the best. I used the ring type that must be installed with the spring out.
They don't seem to change the dynamics of the spring tension, or the ride quality.
are they rubber or metal and do you know who sells them? THANX SMITTY
Global west sells a aluminum c shaped spacer. NOTE,,,,,,I said previously that a 1/2 inch would raise it 1 1/2 inches, that is not correct according to global west. I remembered it as 3 times width of spacer but may be my memory has faded a little!!!. So to raise 1 1/2 inches a 3/4 inch spacer is needed. The c shaped spacer allows just jacking up spring and inserting the spacer . I have installed a bunch of these with the plate that goes between coil and a base plate that bottle jack sets on is chained to lower control arm. Shock is removed of course . Or you can do by removing spring and set them in pocket. Spacer is much cheaper and you will know how much it will raise compared to a different spring that may or may not end up with height you want. Also with a different higher spring the ride (rough or stiffer) may be affected .This is what I would do ,but it's your choice.are they rubber or metal and do you know who sells them? THANX SMITTY