It might be, I'd have to make sure I clean the hole really well so I don't leave metal shavings in.
I'll take a look later, I have the parts in the deep freeze to see if that makes putting the ball joint easier to put in. Everything is at a weird angle or size and it makes pressing the parts in and out very, very difficult. Everything slips out of alignment on the press way too easily.
I'll take a look later, I have the parts in the deep freeze to see if that makes putting the ball joint easier to put in. Everything is at a weird angle or size and it makes pressing the parts in and out very, very difficult. Everything slips out of alignment on the press way too easily.