ND More 1962 Parts, Fenders, Decklid, Floor Brace and Misc

1

1320dragmonza

Active Member
#1
#1
All prices are plus shipping. Located in Fargo, ND.

ADDED - Rocker molding, bent see pics. *FREE* if someone can use it.

Pair of fenders, both need patch panels and support repair $150 pair

C.A.R.S. floor brace $75

***SOLD*** Axles and third member, NOT Posi $50

***SOLD*** Misc engine brackets for alternator see pics. Open to cheap offers

***SOLD***Hood Hinges $30 pair

NICE Trunk lid $200

Cowl Panel
*FREE* if someone can use it.​

Front Splash Shield
*FREE* if someone can use it.​


Bill
 

Attachments

Last edited:
pvs409

pvs409

Well Known Member
Supporting Member 7
#5
#5
Bill
what other numbers are on the rear end housing?
i was wondering what year the rear end is.
I need another 3:08 ring and pinion, if Carmine does not want them
Paul
 
pvs409

pvs409

Well Known Member
Supporting Member 7
#8
#8
Does it have a BW or BX stamped on the other side of the housing.(stamped into the metal)
And I forgot to ask about ring and pinion condition and few pictures of the ring and pinion.
Paul
 
1

1320dragmonza

Active Member
#9
#9
Sorry Paul, I replied on Saturday on my phone, but see the response didn't actually post. so here goes again.

See attached pics, but can only make out the B, so unknown if W or X.

Unit sat in a trunk of a car or years before I got it, so some surface rust, also, axle and spiders are shot in it. Ring and pinion look usable yet.

Bill

IMG_20181020_164216163.jpg IMG_20181020_164240892.jpg IMG_20181021_135757554.jpg IMG_20181021_135812043.jpg
 
pvs409

pvs409

Well Known Member
Supporting Member 7
#10
#10
BX or BW are both codes for 3:08 ring and pinion.
The ring gear should have the ratio on it as does the pinion gear (as I recall)
I think its a 1959 Chevy rear end.

I think you could ship it in a tall 5 gallon bucket.
I actually only need the ring and pinion -$ 50 is OK.

we are in Michigan until next Tuesday.

Paul Stensland
 
You must log in or register to reply here.
Top