Motor installation

Silversport 63

Well Known Member
Hey guys I just dropped my motor in so I could measure the drive line for my tremec swap and the motor really sags I've never seen this before I have wood blocks between the firewall and the back of the block is this going to be ok until this Saturday or should I put the floor jack under to hold it up
 

Don Jacks

Well Seasoned Member
Supporting Member 3
Put a block of wood on the jack and place it under the oil pan.When you go to checking your angles,you're going to need it anyway.
 

pvs409

Well Known Member
Supporting Member 11
You are going to have to cut out the entire tunnel in front of the seat and raise it at least 2 inches to fit a Tremec in your car.
Paul
 
Top