OUR ENGINE RUN STAND

Jim Sullivan

Well Known Member
Supporting Member 10
62 bubble and myself have removed his 348 from his '62 driver. He will be using the 348 in his bubble top we are building(in another thread). So we freshened up a 283 for this 62. This is a shot of our engine run stand and the 62. We built the stand using an old boat trailer and the front part of a badly rotted frame. 100_2757.JPG The engine ready to be taken off of the stand.100_2756.JPG 100_2758.JPG
 

Jim Sullivan

Well Known Member
Supporting Member 10
Thanks guys. I have another old boat trailer and may be making a second run stand. This time I don't think I will cut the trailer down as short and I will leave the frame a little longer to include the trans cross member. If anyone is going to make a similar stand, take note of where the exhaust will exit and attach it to the trailer accordingly. I didn't pay much attention when I bolted the frame to the trailer and had fabricate different rear spring shackles to allow exhaust clearance.
 
Top