Power steering pump

nana1962409

Well Known Member
Supporting Member 2
Would he need the cast pulley for the pump too? I know for 62 they used it but not sure on 63 or 64 being in not as familiar with them.
 

rich hunter

Active Member
I have the cast pulley and it lines up well with some shimming on the show case parts. I was concerned about the angle of the small block pump as it doesn't install as upright on the 409. The challenge will be with the top bracket of the two supplied. Going to need some fabrication for the Wilson Headers... all good, tomorrows project... Thanks
 

rich hunter

Active Member
Yes same, three would be about right. How does the car sound with the Wilson headers? Was sure impressed with the fit and clearances with my dummy block...
 
Top