rear end

rconnors

rconnors

Active Member
Currently running a ZZ4 GM crate 350 with 355 hp stock ram horns at 2.25 inch with 350 trans....62 impala has stock rear end. Want to upgrade to a posi...what do I need for a complete conversion?
 
models916

models916

Well Known Member
Supporting Member 7
Use And Aftermarket

Auburn, Strange and Eaton now make posi units for the 58-64 fullsize Chevy. Somewhere around $400-$500. ALL MUCH stronger than the orig GM unit. Moser makes axles for around $300. Show Cars has bearing cap supports for $150.
 
CDNpontiac409guy

CDNpontiac409guy

Banned
models916 said:
Auburn, Strange and Eaton now make posi units for the 58-64 fullsize Chevy. Somewhere around $400-$500. ALL MUCH stronger than the orig GM unit.
Click to expand...

The Eaton unit is repotedly the better of the aftermarket parts.
However, Models... you are in error.... the aftermarket is no where NEAR the unit of the factory "4 spider" power Lok... not even close.
Also, no possibility of the 30 spline axle upgrade.

As for Show Cars bearing cap support...
They've attempted to copy a few of my designs/products ( DESPERATELY trying to get Ross Pistons to supply them with my proprietary design )...
In this particular instance, they fall short again.
For an extra few dollars, you can get a part that's made by a career tool and die maker, that has been proven OVER and OVER again.

Perhaps Show Cars can chime in and offer the technical information and advice ?


sorry...
tired of dancing around this subject:coffee:

Thank you, Bob:bow
 
dq409

dq409

Well Known Member
Supporting Member 3
CDNpontiac409guy said:
Perhaps Show Cars can chime in and offer the technical information and advice ?


sorry...
tired of dancing around this subject:coffee:

Thank you, Bob:bow
Click to expand...

ATTA BOY OZ !!!!:clap

Go after those Sh*t bags rip offs!!!,,,dq
Oz knows how I also feel about people that rip off your hard work
 
You must log in or register to reply here.
Top