Template for dash tach cutout

Skip FIx

Well Known Member
#1
Anyone have a template for the dash tach cutout ? I can kind of ballpark the top part just not sure how far to go down the bottom curve to the 2 screws.
 

Skip FIx

Well Known Member
#4
A picture of the curve down the the bottom, so maybe distance to cut from top back hole. I can figure width and depth on the top based on tach(Autometer will fit in there, back in the day swapped in a Sun Super Tach) but not sure how far down to cut and then bend to match up to the housing.

Thanks Don I just did not see that when I ordered the housing a few years at figure it out I may order one. Want to cut it before I paint it. Going form blue to black.
 

Skip FIx

Well Known Member
#7
Thanks that gives me some direction. I figure a Dremel cut off wheel would be the easiest to not bend the thin stuff. Not looking to make it look like a total original dash but close. The bottom I was not sure how to do to still cover up the tach.
 
Top