Late great Chevy showing upper off set camber shaft kit for 1958 to 1964. $163.00 each.
The quest for more + caster
- Thread starter Jim Sullivan
- Start date
montemike79
Well Known Member
Jim, we were going to do just that. I have a '62 Bel Air that I'm redoing and planning on putting all tubular arms on it, I was going to take the uppers off of that and modify those, as well as put all new bushings in his car top and bottom. They don't look horrible, but we are going to replace them so we never have to worry about them again.
Don, I checked those shafts out before, but they only have 1 degree of camber and I believe 2 degrees of caster built in them, which isn't enough to correct what we have, plus the cost per side. I appreciate it though.
Don, I checked those shafts out before, but they only have 1 degree of camber and I believe 2 degrees of caster built in them, which isn't enough to correct what we have, plus the cost per side. I appreciate it though.
Found it Jim, thanks.
Did you ever get the car on the road for a test drive?
Later
Dave
Did you ever get the car on the road for a test drive?
Later
Dave
Sure did Dave, car is much more stable at highway speeds with the added + caster.