Tooth's 30 chevy coupe /409

Tooth

Well Known Member
Supporting Member 3
:yupDurrrrrrr, you got a block you want to donate? so I guess if you could make 800to 1000 horsepower as long as you didn't turn it over 6500 RPM? Doesn't seem right to me. That would take a lot of bore, stroke, and compression......
 
Last edited:

Tooth

Well Known Member
Supporting Member 3
Looks like the 348 patient is on the table and getting ready to get decked and sleeve put in #3 hole (small crack)... Everything else checks okay. Going to leave at standard bore for now and probably build a stroker motor out of it someday, have a nice standard-standard 409 crank and set of rods that have been magnaflux and checked for cracks.:brow The Coupe block will be on deck :laugh soon.... get it? That's for you Phil!!!!!!!!!!!!
20191112_113609.jpg
 

Phil Reed

Well Seasoned Member
Supporting Member 10
Mr. Lobb....you are absolutely in a class of your own!!!!!!! All these years I was going to have Delmer to adopt me but........I'm starting to change my mind to you!!!!!!!!!!!!! Just think, I'd be closer to help you to help your Z-11 after tha fiasco Al had with it!!!!!!!!!!! Tell Al I love him!!!!!!!!!!
 
Top