YOURS, MINE & OURS PART 2

pvs409

Well Known Member
Supporting Member 11
I just know its easier to transfer the holes from the original 1/4s and fenders - I made paper templates for the fender flags and 409 emblems plus
I made templates for Impala emblems and Impala script(but not the 1/4 belair script)
So trying to help with suggestions for Dennis....
 

Phil Reed

Well Seasoned Member
Supporting Member 10
Have Dennis to pay you to go to Springfield and do it correctly!!!!! Can you stop by and pick me up too?????
 

Phalen409

Well Known Member
Supporting Member 6
2 coats of primer and initial block. This is tough for me not being there to see first hand, as I was very much involved with the last two projects!!

However.....my guy doing the work probably looks the quiet and my not hovering over his shoulder!!

IMG_20200925_182905864.jpg2000000000017898.jpegIMG_20200925_182852171.jpgIMG_20200925_182919265.jpg
IMG_20200925_182858950.jpg



This passenger door is door # two. The first one had the skin removed and a repo was placed on the original door. Fitment was horrible and NOTHING could be lined up to the quarter OR front fender. # 2 door was bad on the bottom of original skin. Cut approx. 6 inches of the original skin and used the lower repo door skin to replace the bad lower original skin. Hell of a job and well done. You local forum guys (Missouri area) should consider Rodney for your work. Honest and easy to work with.
 
Top