Simps37

Seats are bolted in!!!!!

Floor is FINISHED!!!!!!!!!!

Hope to finish the floor tomorrow or Friday!

Welded in

What engine? What car? Just a note on cooling a SBC in a hotrod, it is way easier to cool than a 409. A small block is no problem My...

37 Chevy coupe. 409 stroker with big Walker Radiator and big SPAL fan from Cooling Components. I have put a 180 in it and will see how...

Scrap metal driveshaft tunnel…….YEAH BABY!!!

Back in and running…..starter issues behind me. Next step is finishing floor driveshaft tunnel and tranny cover.

In Texas…..big Walker Radiator with AC(soon I hope)……automatic transmission…… 180 or 160 temp thermostat? Thanks Fellas!

Yayyyyyy!!!

Scrap angle iron……zip ties……Equals brake switch installed!

Ok……front upper/lower control arm bushings and grease cups replaced….I had built this suspension 15-18 years ago and the rubber was dry...

Put the new flex plate and new starter on last night……had plugs out and spun engine over to check fit. Starter to flex plate looked good...

New glass/seals/window tracks are ordered. Since I built this front end about……16 years ago(had to pull off my boots to count that...