Recent content by hrlykngt

What is everyone doing to run the newer AVS style Carb with the stock air cleaner, do they make an adapter that goes from carb smaller to breather? Hate to cut this original breather to fit these new carbs. Would adapter choke down the air to much?

Another piece of the puzzle came home! Bought this air cleaner for a 1962 Chevy 409. You can see my profile picture and other pictures below of My Daddy and his Friend Ken Brown and the 62 Impala they raced. This 62 Impala had the 62 409/409 when they started racing in 63 or so, in late 64-65...

Its looking like Cometic. I went to their website and they show gaskets from .020 all the way to .080 in several increments, this will help alot if I have to get this deck cut again, it has been cut already I know since numbers are gone. What are the 4.437 Gaskets for, that would be a .125 over...

What are the best head gaskets to run with the aluminum heads, I have heard composite? From what I have been searching on here lots of folks had problems with Felpro 8007's.

May be over thinking this. I probably wouldn’t have given it a second thought on one of my old small block builds back when I was racing years ago . I got my deck of the block cleaned up. I used a nylon brush wheel to clean without removing any material. This block was decked before I got it. I...

I picked up a Edelbrock 409 with a motor I bought awhile back, the pump only ran about 20 minutes and motor had issue and was torn back down. The pump sat since 2010 and when I tried to first turn impeller it wouldnt turn then finally did, I would like to rebuild this as these are expensive...

Thanks, is there a lip in housing or is hole same size all the way thru?

Has anyone used one? Does it fit behind stock water pumps ok? The seal looks odd size or something, I looked them up and they said it came with seal but couldnt tell if it was factory seal. Almost looks like it goes in from rear from picture.

Do they still make this cover? looking for options since running roller cam, I had purchased a new raw cover from show cars and was going to weld the small plate in groves, just looking to see what other folks are doing with roller cam setups.

More Pics of Bumpers and Fenders

NONE OF THIS IS FOR SALE, Just Sharing for those who havent seen before. Here is something you wont see many sets out there for a 62. I think they were originally manufactured by Aeroglass Fabrication in Georgia. I dont think they make car parts any longer. I bought them several years ago from...

Thanks, I found a nice used set someone swapped gonna have $200 in them shipped . If they are as good as pics show I will have what I need.

Will see, said should ship next week.

For anyone interested. I found a company that makes a copy of the Moog 6004, they are Mevotech, supposed to be made in the USA. Part # SMS 6004, found them on AMAZON for $90. I ordered a set and will try them out. https://www.mevotech.com/part//SMS6004 I contacted their Tech Support and it is...

For anyone interested, all of the springs I listed above are discontinued, I couldn't find any of them. I found a company that makes a copy of the Moog 6004, they are Mevotech, supposed to be made in the USA. Part # SMS 6004, found them on AMAZON for $90...