Recent content by Markuhri

Where can I find these? 1961-1964 Chevy Impala Convertible Upper Windshield Header Molding Clips Set

No sign of that .

Heck of a vibration.on right turns

New trans mount.

Sitting on the ground. All 4 wheels, not supported. Learned that (remembered) after blowing a carrier bearing apart after 30 miles.

When I turn to the right it makes a horrible grinding noise from the tunnel of the driveshaft. New carrier bearing and u joints. I can figure it out and is really annoying. Any ideas?

I totally agree

Nothing against show cars, but this is a budget build and they are about $30 higher than comp Cams on everything. I know guys have used 333 truck heads before.

I am needing help. Again!!!. What springs, retainers, and rotator eliminator do I need for a 333 truck head. Looking at a 901 showcar cam or a step up from that.

These are mild ported 333 truck heads. What size valves should I put in while I am putting in seats in the exhaust?

The seats are completely shot

Are they needed in the intake and exhaust? I have heard both, and some just the exhaust?

No. It is a mild car build.

I have one...

So, it starts to begin again. 30 years later. I got the new pistons and rings. Heads are at the shop getting hardened seats. Now to figure out a cam and springs for the heads. I still want to run the rotators. Any suggestions on cam and springs? Readt to measure for the main and rod bearings.