Jayz63
Well Known Member
Hey every one. I hope all is well in the 409 world. I’m trying to figure out if my clutch rod is too short from my pedal. I believe it’s about 20-21”. I have it fully adjusted out and I’m not sure if I have a clutch disc issue or a push rod issue. I have the correct z bar and fork. I was thinking about trying a longer rod before replacing the clutch. The problems I’m getting is when I start the car the reverse gear always seems to grind and after driving it about 30 minutes it’s hard to put it into 1&3 gears. This problem has been getting a little bit more common over the last couple months. Thanks in advance. I’m using a 11” Luk clutch 04049. I had found that the pressure plate for Luk was the only brand that sits in the housing without hitting the walls of the bell housing.