Does anyone know where I can find a diagram for folding Trunk Filler Cardboard
for a 1960 impala convertible. I recently bought the cardboard but no instructions to install. I hesitate to install because once you bend it your stuck with it
Thanks Mike
Does anyone know the significance of the two painted lines that run around the drive shaft. I have a 60 impala and there are 2 Orange lines a 1/2 inch wide
Thanks
Mike
Thanks
Tom and Rock
Thanks for the reply,I would like to go factory correct but am on somewhat of a budget. I've heard of Eastwood Co. and their paints are supposed to be a good match to correct.
I'll order some and see how it looks, if not there goes my budget. Thanks again...
Hi All
I need to detail the underhood area of my 1960 Impala.
Does anyone know what black color paint I should use to do the Wheel wells/ and firewall Flat ? Semi Gloss? Gloss? and what Brand names are readily available in the stores
Thanks Mike:confused: :confused:
what is the best type of spark plug that I can use in my 60 /348
4bbl. I know the book calls for AC 44N but what about platinum
are they better.
Thanks
Mike
Hi Guys
You all were a big help to me regarding my last question about
the 3x2 air cleaner thanks again
Now I want to pick your brains and find out what is the best spark plug i can use in my 60 impala 348/250hp/carter.
Manufacturer recommends AC 44N but i've heard alot of other...
hi
Sorry I caused so much confusion.
But i didn't know how else to describe the air breather
intake horns.
I appreciate everyones input
Thanks Again
Mike
Hi
DDay1
Now thats exactly what i was talking about the distance between those intake horns are a lot greater then the one i'm contracting to get. Would yours for your 61 be the same as
one for my 60 348?
Thanks alot
You've confirmed my suspicions
Mike
hi
Sorry I caused so much confusion.
But i didn't know how else to describe the air breather
intake horns.
I appreciate everyones input
Thanks Again
Mike
your'e right tommy
you're right tommy i need to know the distancebetween the air intake horns the breather i have is supposed to be for a 60
348 3x2 set up. On the breather there are two intake horns. what if you know is the distance between them,on the breather i have they are 6 inches apart...
thanks
thanks
but my concern is the distance between the air horns the one i'm looking at is only six inches apart from each other
I think this is too close for a chevy breather
Thanks Mike