Recent content by 62 Impala 4dr

When I put my old pads I got from you they worked fine I think the spring clip made better and stronger than the new ones I got.

Yes they were in the ramps and tight they had less than 20 miles on them. they're seem as god quality as the ones I got with the kit.

here are the pictures

The ones that came with the kit I got from you . I bought 2 sets from o'reillys auto and both outboard pads went to hell one bent the clips holding the pad and the other one the clip broke off completely allowing the pad to slid down I have pictures. Looking for better quality

Hello I am wondering what brake pads I should use in my calipers

I got all back together seems much better slight drag and both wheels seem the same. Calipers stop and release as before all that's left is a test drive

here's a pictures of old and new out board pad and passenger side caliper

I unhooked both the line from the caliper and opened bleeder and still stuck

yes they slide into position when first installed

I'll take them tomorrow but open bleeder seems better I hear a little drag when turning rotors

I'll go and check

The caliper move without pads back and forth

there is about 1/4 inch left on outboard pads, no residual vavles

No it didn't either with the hose or bleeder

have installed Mike Garcia's disc brake conversion kit. Using a 8" dual booster, corvette shallow m/c, chevy style prop valve. The problem now is the front disc brake lock up and won't release unless I push back the caliper by hand. the outboard pads are worn down by half inboards look good. I...