Recent content by rickiie

Just Found The Problem i Allowed Entirely To Much Air To Enter The System after I Removed The Filler Plug With Top In The Down Position I Added A Little More Fluid Left The Filler Plug Out And Then Raised The Top, It Blew The Breaker But Almost Ran Through Its Complete Cycle. I Lowereed Top...

i need some help just changed my convertible top pump, cylinders, and hoses. bled system like it says in the instructions but every time i operate the top in either direction a breaker of sometype blows and stops operation of top after a few seconds it comes back on and lets me resume operating...

Well The 283 Started Fine Runs Great The Only Problem I'm Having Now Is The Kickdown Linkage Rods Both From The Carb And The One From The Tranny Are Real Loose Once They Were Sandblasted And Cleaned They Just Fall Off The Nipples On The Bell Crank I Think They Oringinally Came With Some Type Of...

Thanks To All Well What I Did Was Go And By A Performer 2101 Drilled The Hole At The Oil Tube Provisionthanks 55 Chevy 283 So I Could Keep My Stock Valve Covers. Whats Nice About This Manifold Is That It Gives You All The Same Ports As The Stock One Vac Modulator, Heater, Temp Sensor, Alt...

thanks does any one know the adapter that i would need to run this holly 4175 on this intake and thanks to everyone for your quick response

i have a 65 impala with a 4 bbl q-jet intake that i just put on. i bought a holly 4175 from summit racing because it said it would fit a qjet when i got it i put the gasket on first the stud flange bolts line up but the intake ports are no where near lined up is ther something i'm missing. the...

i have a 65 impala 283, came with a two bbl rochester i wanted to change it to a four barrel. the intake i bought off ebay looks great but i realized that there is no vacuum modulator port on it like the 2 bbl intake can i tee off of another vacuum like the carb or the dist please help i'm...

NEED SOME INPUT? I HAVE A 65 IMPALA SS WITH A 283 IT CAME WITH A ROCHESTER 2 BBL. I JUST PURCHASED A 4 BARREL INTAKE CAST #3783244 Chevy 327 / 250 HP. IT WILL ACCEPT BOTH A ROCHESTER QJET OR A WCFB . WHICH WOULD GIVE ME BETTER PERFORMANCE AND RELIABLITY. COST IS NOT AN ISSUE, ALSO THE CAR DOES...

thanks for your fast reply ggod info i was wondering though if it would be all right to install both the spacer and the shroud i live in hawaii and it can get pretty hot here

i have a 65 that i'm restoring my question is when i bought this car it did'nt come with either a fan shroud or the spacer that goes between the radiator and frame did these cars with a 283 come with both? or just one. shroud or spacer?