Is there any need to check the Valve clearance on my 348.
This is what I have:
348 .060 over
10:5 Forged Pistons
Show Cars 0951 Comp Hydraulic Cam .530 intake and .535 exhaust valve lift
Scorpion Roller Rockers Arms 1.75-7/16
Edelbrock Aluminum Heads
Do I need to worry about Clearances?
I was wanting to install my heads and final torque them but I don't have my pushrods yet, so I can't check my clearance.
Valve to Piston should be fine with the 10.5 pistons but I concerned about the exhaust valve to the bore.
Should I be concerned?
This is what I have:
348 .060 over
10:5 Forged Pistons
Show Cars 0951 Comp Hydraulic Cam .530 intake and .535 exhaust valve lift
Scorpion Roller Rockers Arms 1.75-7/16
Edelbrock Aluminum Heads
Do I need to worry about Clearances?
I was wanting to install my heads and final torque them but I don't have my pushrods yet, so I can't check my clearance.
Valve to Piston should be fine with the 10.5 pistons but I concerned about the exhaust valve to the bore.
Should I be concerned?