Have installed an additional control arm on my 63 Impala. My problem is that with it installed and putting on the panhard bar the entire assemble appears to be pulled to the left side and the control arms look sort of like / / instead of straight.
I bought the parts from show cars and they had an instruction sheet on spacing of the brackets and I am on the money.
Is this normal without the weight on the frame? Anybody have a pic or to or some dimensions showing the proper locations and spacing for the brackets on the frame and the rear end housing?
Also when I put the panhard bar on I had to pull the axle housing to the left about 2 inches to get the bolt in the hole.
I feel that there may have been a mistake in the instructions or I don't know what I am doing?
Help
Ed
I bought the parts from show cars and they had an instruction sheet on spacing of the brackets and I am on the money.
Is this normal without the weight on the frame? Anybody have a pic or to or some dimensions showing the proper locations and spacing for the brackets on the frame and the rear end housing?
Also when I put the panhard bar on I had to pull the axle housing to the left about 2 inches to get the bolt in the hole.
I feel that there may have been a mistake in the instructions or I don't know what I am doing?
Help
Ed