Cam choice stock 348 with tri power

[Don Jacks]

Oh yeah,Charlie can do you a nice little cam.

 

[boxerdog]

Charlie is a very interesting guy to talk to.

 

[neilswheels]

Good luck. I emailed them 2 months ago....takes a long time to get there from Iowa. Probably ended up in Hawaii...

Ha ha, yep, whe I emailed them, their email address popped up immediately, I then remember emailing them before and not receiving a reply, probably why I was looking at comp cams on summit

 

[neilswheels]

Something else you might give a try:

https://www.camcraftcams.com/

I’ve just emailed Charlie, thanks.

 

[Don Jacks]

I just pick up the phone and call them.

 

[neilswheels]

Something else you might give a try:

https://www.camcraftcams.com/

I’ve just emailed Charlie, thanks.

 

[neilswheels]

I take it back, Competion Products have replied, it’s a 4-6 week wait in a cam from Howard’s, and uses stock pushrods. Thanks all, decision time.

 

[neilswheels]

Ive tried emailing Howard and Isky direct, but no reply from either, Now trying Summit, as they are an Isky dealer, see what happens. Good thing about Sumit is that they are used to dealing with 'out of towners', and are setup to ship to the UK.

 

[303Radar]

Try Bullet Cams:
https://www.bulletcams.com/
They have an online form you can fill out with your desired outcome. I bought my cam from them for my 431.

 

[SSpev]

I second Bullet. I picked my own lobes and they made it. You could do the same just match up there lobes with another cam and have that made.

 

[SSpev]

these are more than stock but mild hydraulic flats. I'd do 112 LC with 4 deg adv
just my first guess
master adv 50 200 lobe lift
H275/267 275 220 116 .2670
H271/267 271 216 113 .2670

 

[neilswheels]

So I have finally received my Isky cam, 241262, hard work dealing with Summit on this, and although I ordered, and assume paid for a 'Cam Kit', i've only received the cam.. but at least I have it. Plan to get it to the engine builder asap, and get the rebuild rolling again.

Thanks for everyone's input, much appreciated

 

[Corndog Man]

I have not started mine since built probably 30 years ago. Don't ask. Here is the camshaft I have. It is a Crane.