Dist primary lead wire

[Impalaguru]

I'm sure I'll get my answer here, but I need to replace the lead wire on my dist (coil to points). Its dist # 1110930 (1958 348). It was in my 63 409, for many years, with the 409 balast resistor, and worked fine. I'm unsure if this lead wire is a resistor wire or some other variety of special wire. The one in the book at the parts store fit a variety of applications but was over 20 inches long. To me that seemed a little too long. Does anyone know the correct application for my set up? Any part numbers? Thanks for the help!!!
Ross

 

[dq409]

Should be just standard wire. Not sure what guage but just compare and get the same size. You can then solder on the ends and use some shrink tube.
The resister wire would be coming from the ignition if a block resister is not used.
If you are going for a points judged car then you will need to find a stock one,,dq