This is the experience I want to have. The concern I have is the fuel injection. I'm curious how much I'll have to modify them to mount up with the regulator.At one time, you couldn't convince me to buy pre bent lines. Wanted nothing to do with them. Made my own including brake lines. When I considered putting new gas lines in my '62, I bought the pre bent ones. Thought I'd give them a try. Followed the instructions and unbent them. I think there were 2-3 different lines. Have to tell you, those things fit like a glove. Only had to slightly tweak one line. Very satisfied with them. Definitely would install then again. Unless it was a single small line, I don't see me ever making lines again. If I could add, I also changed the brake lines on my '71 GTO, with the prebent ones. Only way for me to go, Carmine.
Rubber or plastic. Only kidding of course. I really don't know of anything other then regular steel and stainless. I have made gas lines from the fuel pump to the carb. before, using airplane grade aluminum tubing. I was told that the tubing could fracture from the vibration. Hmmmm……………....Good enough for an airplane, good enough for me. Never had any problems with it. Never used stainless steel, but heard it was very hard to flare, Carmine.I was afraid of that.What would be a rust resistant alternative that is easier to work with? Or does anything like that exist? Thank you Mr LA