Here's the picture. I have two Edelbrock 600's on an Offenhauser high rise manifold. I would like to hard line my fuel lines without rubber hoses. Elelbrock uses a 5/8-20 thread into it's carbs. Holley uses 5/8-18. I bought two 5/8 -18 inverted flare adapters from Edelbrock to replace the hose fittings on the carbs.
Now here lies the problem. I need to 90 degree straight down to a 3/8 inverted flare, instead of coming straight out the side of my carbs with steel lines. I can't bend a steel line sharp enough to 90 down and back inside the valve covers. I can find no 90 degree fittings that go from male to female inverted flare, and I don't want to use colored AN fittings.
Any help will be appreciated.
dave in denver
Now here lies the problem. I need to 90 degree straight down to a 3/8 inverted flare, instead of coming straight out the side of my carbs with steel lines. I can't bend a steel line sharp enough to 90 down and back inside the valve covers. I can find no 90 degree fittings that go from male to female inverted flare, and I don't want to use colored AN fittings.
Any help will be appreciated.
dave in denver