Here's something I made to make welding (mig) or beveling a pipe edge easier. It's a set of rollers that work in conjunction with the holes in my Certiflat welding table.
It can accept any size pipe from drinking straw size up to 6 inches or more! Alignment pins on bottom fit into the holes in the table which automatically sets them in parallel with each other. A set screw on each allows the rollers to move inward or outward as needed. They have 1.5 inch steel rollers that spin on brass axle shafts.
It can accept any size pipe from drinking straw size up to 6 inches or more! Alignment pins on bottom fit into the holes in the table which automatically sets them in parallel with each other. A set screw on each allows the rollers to move inward or outward as needed. They have 1.5 inch steel rollers that spin on brass axle shafts.